Wednesday, May 20, 2015 12:46 PM - Shuai
Windows "net use" command
Hi,
Just tried to run "net use" inside xshell to show my shared drive links. But got output as following.
[C:\Users\Downloads]$ net use
New connections will not be remembered.
There are no entries in the list.
However if I run the same command in windows CMD, I got
Microsoft Windows [Version 6.3.9600]
(c) 2013 Microsoft Corporation. All rights reserved.
C:\Users\test>net use
New connections will not be remembered.
Status Local Remote Network
-------------------------------------------------------------------------------
OK I: \\test-san\it Microsoft Windows Network
OK S: \\test-san\shared Microsoft Windows Network
OK U: \\test-san\users\test Microsoft Windows Network
Disconnected \\172.16.91.120\c$ Microsoft Windows Network
Disconnected \\172.16.91.12\c$ Microsoft Windows Network
The command completed successfully.
So there is still some limitation utilizing the windows built in commands in Xshell v5?
Program Ver. : Xshell 5
Just tried to run "net use" inside xshell to show my shared drive links. But got output as following.
[C:\Users\Downloads]$ net use
New connections will not be remembered.
There are no entries in the list.
However if I run the same command in windows CMD, I got
Microsoft Windows [Version 6.3.9600]
(c) 2013 Microsoft Corporation. All rights reserved.
C:\Users\test>net use
New connections will not be remembered.
Status Local Remote Network
-------------------------------------------------------------------------------
OK I: \\test-san\it Microsoft Windows Network
OK S: \\test-san\shared Microsoft Windows Network
OK U: \\test-san\users\test Microsoft Windows Network
Disconnected \\172.16.91.120\c$ Microsoft Windows Network
Disconnected \\172.16.91.12\c$ Microsoft Windows Network
The command completed successfully.
So there is still some limitation utilizing the windows built in commands in Xshell v5?
Program Ver. : Xshell 5