Xshell Forum

shell over serial

Last post: Saturday, May 12, 2012 10:58 AM by koops, 4 reply

 
Saturday, February 4, 2012 8:03 AM - koops

shell over serial

 
shell over serial response slowly.
delay couple seconds sometimes.
it works well on xshell 3.

Program Ver. : Xshell 4
Monday, February 6, 2012 5:21 PM - Support

Re: shell over serial

 
Thank you for using Xshell.

This issue is caused by new drawing method introduced in the new program framework we used in Xshell 4. But, it just looks slower because it draws block of information at a time instead of drawing a line at a time.

To compare speed with Xshell 3, try using the following command to check the time to complete a command:

time ls -R

Our developers are working on this issue to make drawing more smooth on serial connection.


---
Technical Support
Tuesday, February 14, 2012 7:06 AM - Vincent

Re: shell over serial

 
I found this problem too,It take a lot of time to display router's large config file (e.g. show tech-support)
Tuesday, February 14, 2012 11:05 AM - Support

Re: shell over serial

 
The total time it takes to finish the same command should be about the same for both Xshell 3 and 4. It just looks slower on version 4 becuase a chunk of information is drawn instead of line by line.

Our developers are on this issue.

---
Technical Support
Saturday, May 12, 2012 10:58 AM - koops

Re: shell over serial

 
i don't think so. it happen only when i use xshell 4 on a uart serial.